To Operate The Product - Husqvarna WS 442 Manual Del Usuario

Ocultar thumbs Ver también para WS 442:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Select the remote control settings:
>>DRIVE CHOICES
SET GEAR
[GEAR 1]
SET DRIVE MODE
[BLADE]
SET ROT. DIR.
[STANDARD]
SET FUSE
[32A]
a) SET GEAR: Select gear (A). For more
information on recommended blades and
speeds. Refer to
page 17 .
b) SET DRIVE MODE: Set the mode to BLADE (B).
c) SET ROT. DIR: Select the direction of rotation of
the blade (C). The direction of rotation can only
be changed when the blade is stationary.
Note: (S) = Standard, (R) = Rearward.
3. Move the product to the start position. Make sure
that the blade does not touch the material.
4. Start the water supply for the cooling system. Adjust
the flow with the water tap.
5. To start the motor, press the arrow button and at the
same time turn the blade speed dial clockwise. The
motor power output is shown in the display on the
remote control.

To operate the product

1. Start the product. Refer to
page 10 .
2. Control the product with the remote control. Refer to
To operate the remote control on page 14 .
1094 - 002 - 26.09.2019
20 DEC
20:55
A
B
C
Recommended blade speed on
OK
ON/OFF
0
To start the product on
3. Do a guide cut to a depth of 2-4 cm/0.8-1.6 in (A).
Make sure that the power output of the blade motor
is 60-65%. This to make sure that the guide cut is
straight. Do not cut into rebar.
A
B
CAUTION: Do not use full throttle for the
guide cut.
4. Set the longitudinal speed to maximum. The speed
is automatically adjusted to get the best sawing
effect. If the power output is lower than 100% during
the these cuts, the cutting depth can be carefully
increased.
5. Do subsequent cuts to a depth of 4-7 cm/1.6-2.8 in
(B). The hardness of the concrete and the quantity
and position of reinforcement have an effect on the
cutting depth.
Note: You can change the blade and cut in the same
cut. Make sure that the thickness of the new blade
aligns with the groove width.
a) If the product runs on 1 phase operation, the
power output is decreased. The cutting depth
must be decreased compared to 3 phase
operation. Decrease the cutting depth by ½.
b) When you cut rebar from end to end, cut the
rebar as the illustration shows to keep the blade
sharp. If the rebar does not follow the sawing
groove from start to end, start the cut from the
other end.
11

Publicidad

Tabla de contenido
loading

Tabla de contenido