To Start The Product With A Cold Engine - Husqvarna K1270 II Manual Del Usuario

To start the product with a cold engine

WARNING: Make sure that the cutting blade
can rotate freely. It starts to rotate when the
engine starts.
1. Push the decompression valve to decrease the
pressure in the cylinder. The decompression valve
goes back to its initial position when the product
starts.
2. Make sure that the STOP switch is in the left
position.
22
3. Pull the choke control fully to get the start throttle
position.
4. Push the air purge bulb 6 times until it is fully filled
with fuel.
5. Hold the front handle with your left hand.
6. Put your right foot on the lower section of the rear
handle to push the product against the ground.
WARNING: Do not wind the starter rope
around your hand.
988 - 002 -