Rockwell Automation SP200 Manual De Instrucciones página 21

Drive Parameters
Display Parameters
(Read Only)
Units /
No. Name Default
d-00 Command Frequency 0.1 Hz 0 - 240.0
d-01 Output Frequency 0.1 Hz 0 - 240.0
d-02 Output Current 0.1 A 0 - 200 (% of rated current)
d-03 Bus Voltage 1 V 0 - 1000
d-04 Fault Code Annn alphanumeric code
d-05 Input Status decimal 0000 - 7111
d-06 Drive Rating decimal
d-07 Firmware Version Annn alphanumeric code
d-08 Analog Input 1 Units 0.1 % 0 - 110.0
d-09 Analog Input 2 Units 0.1 % 0 - 110.0
Program Parameters
(Parameters that can be programmed only while the drive
is stopped are indicated by an asterisk *)
Units /
No. Name Default
Group 0: Protection
P-00 Minimum Speed * 0 Hz
P-01 Maximum Speed * 60 Hz Minimum Speed - 240
P-02 Motor Overload Current x.x A
P-03 Reverse Disable * 0
P-04 Auto Restart Attempts 0
P-05 Current Limit 150 % 10% - 150% of drive's rated current x x x
Group 1: Digital Input / Output
P-10 Start Control * 2
P-11 Configurable Input * 2 (A)
1 (B)
0 (C)
Drive Parameters
Model
Range A B C
x x x
x x x
x x x
x x x
x x x
x x x
x x x
x x x
x
Model
Range A B C
0 - Maximum Speed x x x
x x x
20% - 200% of drive's rated current x x x
0 = reverse enabled x x x
1 = reverse disabled
0 - 10 x x x
1 = keypad control x x
2 = 2-wire control x x
3 = 3-wire control x x
0 = function loss (P-10 ≠ 3)
1 = disabled x
1 = preset x
1 = reverse run (2-wire)
2 = jog (P-10 ≠ 1) x x
2 = jog (P-10 ≠ 1 or 3)
3 = alternate spd ref select x x
3 = alt spd ref select (P-10 ≠ 3)
4 = n.c. coast-to-stop x x
4 = n.c. coast-to-stop (P-10 ≠ 3)
5 = secondary accel/decel x x
5 = sec accel/decel (P-10 ≠ 3)
11
x
x
x
x
x
x
x
x
x
x
x