Dirt Devil Ud70095 Manual Del Propietário página 9

DIRT CONTAINER & FILTER: REMOVAL & REPLACEMENT CONTINUED
4. 5.
CLEAN FOAM FILTER RINSE FOAM FILTER
Separate the filter assembly Hold foam filter under running water to rinse. DO NOT
by removing the foam filter use soap/detergent. Ring excess water out of foam
from its plastic housing. Tap filter. Allow foam filter to COMPLETELY DRY for at
the foam filter on the inside least 24 hours.
of a rubbish bin to remove NOTE: The filter housing also needs to be washed
excess dust and dirt from regularly with cold water and dried thoroughly before
filter. replacing and restarting the vacuum cleaner.
7. 8.
REMOVE EXHAUST Press tab on exhaust
FILTER filter and lift filter out
Press tab on front of of base of cleaner.
exhaust cover and lift
F41 Filter
to remove.
10. 11.
REPLACE EXHAUST FILTER Replace exhaust filter cover
Once dry return exhaust filter and snap into place to
to base of cleaner and snap secure.
into place.
Regular Maintenance
Each time the dirt container is emptied, the foam filter should be checked and when necessary, cleaned (Filter will
be discolored after use, this will not affect the filter's performance). Do not brush the filter. The cleaning instructions
may vary depending on the dirt conditions. In some cases, more or less cleaning of the filter may be required.
6.
REPLACE FOAM
FILTER
Once dry
foam filter to cleaner
and snap into place.
Replace foam filter
cover and snap into
place to secure.
9.
CLEAN AND RINSE EXHAUST FILTER
Tap the exhaust filter on the inside of a rubbish bin to remove
excess dust and dirt from filter. Hold filter under running water
to rinse. DO NOT use soap/detergent. Tap excess water out of
exhaust filter. Allow exhaust filter to COMPLETELY DRY for at
least 24 hours.
12.
REPLACE DIRT CONTAINER
Return dirt container to cleaner. Align slot on
bottom of dirt container with tab on cleaner. Push
to snap into place.
8
return