Residual Risks; Disposals/Demolition - Emiliana Serbatoi CARRYTANK 220 Manual De Uso

16. rESIDUAL rISkS

residual risks and relevant regulations present when using CArrytANk
FIRE AND EXPLOSION HAZARD:
– There remains the risk arising from the realization of flying-type electrical connections (e.g. crocodiles), we recommend the preparation,
by the user, of vehicular permanent connection with battery isolator.
– the positive-ignition engines of vehicles with gasoline, natural gas or LPG must be switched off during transfer operations.
– you may not use the transfer device within closed spaces, choosing outdoor open and airy areas at an adequate distance from buildin-
gs.
– Provision should be made for the cleaning and decontamination of workspaces from any spills or oil residues, as well as make sure there
are no flammable materials in the areas (rags, wood, vegetation, pollens, etc.) and that operations are carried out at suitable distance
from sewer manholes.
– The user must provide a powder fire extinguisher ABC min. 2 kg.
– In the event of an outbreak of fire interesting the transfer device or an adjacent area, make sure that you immediately close the fluid
shut-off valve between the tank and the piping of draught, so securing the fuel contained in the fuel tanks.
– It is prohibited to use the machine for pumping flammable liquids other than fuel, except the use of ATEX certified pumps.
– the CArrytANk
is not suitable for operation in areas where it is possible the formation of explosive atmospheres.
®
RISK FROM CONTACT WITH SHARP SURFACES
– During normal operation of the machine, the risk can therefore be regarded as extremely reduced; to carry out maintenance work safely
it is instead necessary to have suitable protective gloves against mechanical risks.
RISK OF HAZARDOUS MATERIAL SPILL
In order to prevent hazardous material spills, you shall:
– Use of the equipment under the direct control of the operator;
– Periodically check the condition of the rubber tube and the presence of traces of dripping from the pump body;
– Unload the residual pressure in the delivery line after each use, before putting the gun to rest;
– Drain the gun adequately within the destination tank inlet, before putting it away in the containment cabinet at rest.
RISK FROM CONTACT WITH HIGH TEMPERATURE PARTS
– Please note that the maximum running time of the pump in by-pass conditions is 2 minutes, after that time there is risk of burns when
touching the pump body;
– Operators (transfer operator and maintainer) should use protective gloves against heat.
RISK FROM EXPOSURE TO DANGEROUS SUBSTANCES
– It is compulsory for the operator to use protective gloves against chemicals (EN 374);
– It is recommended that the operator use a facial mask.
RISKS FROM MANUAL HANDLING OF LOADS
– there remains the risk of physical workload during handling of CArrytANk
depending on the specific use.
We stress, anyway, that the CArrytANk
17. DECOMMISSIONING/DISPOSAL
the dismantled CArrytANk
®
– Emptying the residual oil within appropriate containers.
– For the choice of the most suitable containers for waste disposal, contact the responsible for disposal.
– Confer the CArrytANk , and any other containers to eligible Company regularly registered in the register of waste Companies, and
®
possessing the required permissions for the disposal of hazardous waste.
From the decommissioned CArrytANk
– Plastic material. the entire container in 100% recyclable polyethylene (PELLD), as indicated by the symbol printed on the wall of the
container.
– Metal material. the metal parts, painted or not, are normally recoverable by companies that specialise in the treatment and recovery of
metals.
– Electrical and electronic material. All electrical and electronic equipment must be disposed of by companies specialising in the
disposal of electrical and electronic equipment waste, in compliance with the requirements of Directive 2002/96/EC, which prohibits, for
all equipment bearing the symbol on the product or on its packaging, disposal with unsorted municipal waste. the symbol depicted on
the side, indicates that the product must not be disposed of together with ordinary household waste, but exclusively through the specific
designated collection facilities appointed by the Administration (Government or local bodies).
– Additional parts (tubes, seals, plastic components, wiring, cables), to be disposed by companies that specialise in the disposal of
hazardous waste.
MAN_CArrytANk_rev.0 del 05/2017
should only be operated by experienced operators, we recommend proper training.
®
represents a hazardous waste that must be disposed of:
the following materials can be recovered and recycled:
®
and that cannot be eliminated are summarised below.
®
, this risk must be assessed and quantified by the user
®
37
EN