Assembling And Adjustments; General; Unpacking; Fit The Blade - Husqvarna Soff-Cut 150 Manual De Instrucciones

ASSEMBLING AND ADJUSTMENTS

General

WARNING! The engine should be switched
!
off during operations described in this
chapter unless otherwise stated. Remove
the ignition cable from the spark plug to
prevent accidental engine starting.

Unpacking

• Remove the saw from the package. The saw should be
lifted from the center handle on the roll cage.
• Discard or recycle the packing material per your regional
laws.
• Soff-Cut 150: No diamond cutting blade or skid is
included with the saw. Purchase the appropriate blade
and skid plate from your local Husqvarna Construction
Product dealer.
• Soff-Cut 150 D: No radius or bevel blade is included with
the saw. Purchase the appropriate blade from your local
Husqvarna Construction Product dealer.

Fit the blade

CAUTION! Inspect the blade for damage,
!
cracks, loss of segments, warping,
overheating, excessive wear or a damaged
tri-arbor hole. If the blade shows any of
these problems, discard the blade.
Make sure the blade is marked with a
maximum operating speed greater than 4450
rpm.
Inspect blade flanges for damage, excessive
wear and cleanliness. The blade should fit
snugly on clean, undamaged, tri-arbor shaft.
• Fold the handle to its full upright position.
• Insert the locking pin.
• Raise the blade by pushing down on the handle bar with
both hands to the full and locked position.
• Remove the blade block guard.
• Insert one the two wrenches supplied, in the slot at the
front of the engine and one on the blade shaft bolt.
• Rotate the blade shaft counter-clockwise with wrench on
the blade shaft bolt until the second wrench engages the
flats on the other end of the shaft.
• Remove the blade shaft bolt by continuing to turn the bolt
counter-clockwise.
• Remove the outer blade flange.
• Soff-Cut 150: Discard the old skid plate.
NOTICE! The patented skid plate is the most important part
of the Soff-Cut Ultra Early Entry system. If it is bent, twisted
or damaged, spalling and raveling of a cut may result. Store
skid plates carefully and install them properly. Install a new
skid plate with each new blade. Never re-use skid plates.
• Thoroughly clean the concrete from the shaft, blade block
and blade block guard.
• Mount the clean blade on the blade shaft.
X 150
• Mount the outer blade flange. Tighten the bolt firmly.
• Soff-Cut 150: Install a new skid plate.
X 150 D
– 11
English