Assembling And Adjustments; General; Use With Existing Track; Secure The Base Plate - Husqvarna CS 10 Manual De Instrucciones

ASSEMBLING AND ADJUSTMENTS

General

WARNING! Always position the saw so that
!
you can stand without the risk of being hit
by a broken wire. Ensure that no
unauthorised persons can access the
working area while cutting. Being hit by a
broken wire can result in death or serious
personal injury.
Cutting needs to be planned carefully before assembling the
saw so that it can be performed as easily as possible.
• The saw can both be mounted on the wall and standing on
the ground.
• The saw can be assembled in a right or a left position. This
is useful when you need to cut close to corners.
• It may be necessary to drill holes to thread the wire
through the material to be cut.

Use with existing track

When used with a existing track some adjustments need to be
made.
• Remove the end stops.
• Drill a 15 mm (19/32") hole, 470 mm (18 1/2'') from the top
end of the rail. Use the supplied drill fixture. The hole is
needed when mounting the upper magazine.

Secure the base plate

• Position the saw in an appropriate position in front of the
planned cut.
• Secure the saw with an anchor bolt.
• The distance from cutting line to bolt is 306 mm (12").
• When cutting vertical cuts with the saw mounted on the
wall, the smallest distance from ground to bolt is 615 mm
(24").
• When the base plate is anchored, screw down the
adjuster feet so that the saw stands firmly.
– 7
English