Husqvarna TS70 Manual De Instrucciones página 12

TS70
• To adjust the blade, loosen the four screws holding the
support arm.
• Use the adjustment rod to adjust the blade
perpendicular to the conveyor cart anvil.
• Set the blade in the center of the cutting slot.
• Check again that the blade is perpendicular to the
conveyor cart anvil, the whole side of the blade must
be in contact with the set square. Tighten the
adjustment rod and the four screws holding the
support arm.
12 – English
ASSEMBLING AND ADJUSTMENTS
TS90
• To adjust the blade, loosen the four screws holding the
support arm.
• Use the adjustment screw on the support arm to
adjust the blade perpendicular to the conveyor cart
anvil.
• Set the blade in the center of the cutting slot.
• Check again that the blade is perpendicular to the
conveyor cart anvil, the whole side of the blade must
be in contact with the set square. Tighten the four
screw holding the support arm.