Fill With Coolant; Handle - Husqvarna TS70 Manual De Instrucciones

Fill with coolant

• Lift out the water tank from the saw, hold it upright and
fill with water until the water reaches the opening of
the large hole for the pump.
• If water is filled when the water tank is in place in the
machine, the water level should not rise above the
edge of the smaller hole. Make sure the water level is
always above the low walls where the pump is
located.
• Place the water pump in the water tank. Connect and
place the water hoses as shown below.
• Connect the power cable for the water pump to the
plug on the machine.
ASSEMBLING AND ADJUSTMENTS

Handle

The position of the handle of the cutting arm is reversible
to give an ergonomically correct position for both right and
left-handed persons.
–
English 13