Water Cooling To The Blade; Moving Within The Work Area; Adjustable Stand - Husqvarna TS70 Manual De Instrucciones

Water cooling to the blade

Water cooling through the blade guard should always be
used when miter cutting.
• Turn the water control slightly to adjust the amount of
water on the blade.
When cutting thick or hard materials, it may be necessary
to use both water in the cutting slot and water from the
blade protection. When reaching the slot in the cart, the
water to the blade can be shut off in order to keep the area
as clean as possible.

Moving within the work area

CAUTION! Stop the motor and
!
disconnect the power cable before lifting
or moving the machine.
• Carry the machine using the extendible handles on
the ends.
• Slide back the extendible handles.
OPERATING

Adjustable stand

The stand can be folded away for easy moving and space
saving.
• Fold away the stand by pulling/lightly lifting the rear
handle and loosening the catch. Press together the
stand and secure when folded.
!
• The saw can stand on edge when folded. Supports
are on the cutting arm.
• The integrated wheels allow the saw to be pulled like
a roller bag.
CAUTION! The lock catch must click in
place into its locked position when the
stand is folded.
–
English 19