Plunge Cutting; Dust Handling/Cooling - Husqvarna TS70 Manual De Instrucciones

- 22.5° ° ° ° : Angle the cutting arm until the markings are
opposite each other.
• Lock the knob.
• Tighten the lock knob for the depth setting while
holding the cutting arm in its lowest position.

Plunge cutting

The cutting arm is spring loaded and adjustable up and
down.
• Loosen the lock knob for the depth setting and raise
the blade.
• With the handle on the cutting arm the cutting blade
can adjusts up and down and create a plunge cut in
the work piece.
18 – English
OPERATING

Dust handling/Cooling

The water system circuit (Jet stream system) is used to
reduce dust and cool the blade. The water from the water
pump under the conveyor cart is distributed to the blade
and the cutting slot in the conveyor cart.
When cutting thin materials water is not needed in the
blade guard.
NOTICE! The cutting blade is to be down in the cutting
slot.
Water pump with own on/off valve.
Adjust water flow to bind the cutting dust. The volume of
water required varies depending on the type of job at
hand.
• The valve on the water tank adjusts the flow of water
to the channel in the conveyor cart.
• The valve on the blade guard adjusts the flow to the
blade.