Symbols on the machine:
WARNING! The machine can be a
dangerous tool if used incorrectly or
carelessly, which can cause serious
or fatal injury to the operator or
others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
•
Approved protective helmet
•
Approved hearing protection
•
Protective goggles or a visor
•
Breathing mask
Conforms to UL Std 60745-1,
60745-2-1
Certified to CSA C22.2
No. 60745-1, 60745-2-1
Environmental marking. Symbols
on the product or its packaging
indicate that this product cannot be
handled as domestic waste. It must
instead be submitted to an
appropriate recycling station for the
recovery of electrical and electronic
equipment.
By ensuring that this product is
taken care of correctly, you can help to counteract the
potential negative impact on the environment and people
that can otherwise result through the incorrect waste
management of this product.
For more detailed information about recycling this
product, contact your municipality, your domestic waste
service or the shop from where you purchased the
product.
Ensure that water cannot
leak into the machine
when drilling in the ceiling.
Use an appropriate water
collector and cover the
machine in plastic, but do not cover the air intakes and air
outlets.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
2 – English
KEY TO SYMBOLS
4005474