Inserting The Bobbin - Sears Kenmore 385.11703 Manual De Instrucciones

Inserting the bobbin
Place the bobbin in the bobbin holder with the
thread running off counterclockwise.
(_ Thread
(_ Bobbin holder
Guide the thread into the notch on the front of
the bobbin holder,.
(_) Notch on the front
Draw the thread to the left, sliding it between
the tension spring blades.
Spring blades
Continue to draw the thread lightly until the
thread slips into the notch on the side.
(_) Notch on the side
Pull out about 10 cm (4") of thread to the rear.
Reattach the hook cover plate°
(_ Thread
0 Hook cover
12