Removing The Bobbin; Inserting The Bobbin - Sears Kenmore 385.19000 Manual De Instrucciones

• Removing the Bobbin
Slide the hook cover plate release button to the
right, and remove the cover plate.
(_) Hook cover plate release button
(_) Hook cover plate
\
\
• Inserting the Bobbin
• Place the bobbin in the bobbin holder with the
thread running off counterclockwise.
_) End of thread
Guide the thread into the Notch _) on the front
side of the bobbin holder.
Draw the thread to the left, sliding it between the
tension spring blades.
(_ Notch @
Continue to draw the thread lightly until the thread
slips into Notch (_).
Pull out about 15 cm (6") of thread+
(_) Notch (_)
Attach the hook cover plate.
Check the threading by referring to the chart
shown on the hook cover plate.
(_) Threading chart
14
\