Removing The Hook Cover Plate; Inserting The Bobbin - Sears Kenmore 385.16524000 Manual De Instrucciones

• Removing the hook cover plate
Hook cover plate release button
(_ Hook cover plate
Slide the hook cover plate release button _to the right,
and remove the cover plate (_.
• Inserting the bobbin
End of thread
(_ Notch
Notch
Threading diagram
[] Place a bobbin in the bobbin holder with the thread
running off counterclockwise.
[] Guide the thread into the notch (_on the front side of
the bobbin holder. Draw the thread to the left, sliding it
between the tension spring blades.
[] Continue to draw the thread lightly until the thread slips
into a notch _). Pull out about 6" (15.0 cm) of thread.
[]Attach the hook cover plate. Check the threading by
referring to the diagram (_shown on the hook cover plate.
S
[]
[]
[]
[]
\\\\\\ \\\ _2_
\
7
J
\
\
®
J
24