Machine Setup; Attaching Squeegee Assembly; Installing Brush Or Pad Driver - Nobles Speed Scrubt 2001HD Manual Del Operador

MACHINE SETUP

ATTACHING SQUEEGEE ASSEMBLY

1. Turn off machine.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
2. Pull back on squeegee lift lever to raise squeegee
mount bracket (Figure 3).
3. Loosen two thumb knobs on squeegee assembly
and slide squeegee into slots on squeegee mount
bracket (Figure 4).
4. Tighten thumb knobs securely.
5. Connect vacuum hose from machine to squeegee
assembly (Figure 5).
Speed Scrub 2001HD (09- -04)
FIG. 3
FIG. 4

INSTALLING BRUSH OR PAD DRIVER

1. Turn main switch to the on position.
2. Raise scrub head. Press top half (--) of brush
pressure switch to raise. Hold switch down until
scrub head actuator turns off (Figure 6).
3. Turn off machine.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
4. Unfasten black latch at front of machine and hinge
open skirt housing to access motor hub (Figure 7).
OPERATION
FIG. 5
FIG. 6
FIG. 7
9