Cooling Menu - ECOFOREST ecoGEO HP Serie Manual Usuario

Heating groups
-  +
DG: SG:
5
SG3: SG4:
oom terminals
SetT

DG: 
SG: 
SG3: 
SG4: 
Auxiliary heating X
Emergency:
Support:

3.12. COOLING Menu

User menu 4/8
Heating
ooling
DHW/Legionella prot
4/8 ooling
Enable:
StopT:
Active:
Passive:
ooling buffer
SetT:
DTstart:

ooling groups
-  +
DG: SG:
3
SG3: SG4:
oom terminals
SetT

DG: 
SG: 
SG3: 
SG4: 
Heating groups
-  +
This can be used to adjust the heating target outlet temperatures programmed by the
technical service. Each ramp increases or decreased the outlet temperature by 2ºC.
Room terminals
DTc

Used to show and adjust the inside environment temperature setpoint (SetT) and the

comfort temperature differential (DTc) of the terminals of each outlet unit.



Auxiliary heating X
This is used to enable the auxiliary heating system in both EMERGENCY and SUPPORT
mode.
In EMERGENCY mode, the auxiliary system is activated automatically when any of the
alarms are active.
In SUPPORT mode, the auxiliary system is activated automatically for normal HEAT
production, as programmed by the technical service.
Cooling
This is used to enable the COOLING mode and adjust the active and passive cooling cut-off
8 temperatures. The COOLING mode cannot be activated for outside temperatures under the

cooling cut-off temperature. Only PASSIVE COOLING can be activated for outside
temperatures between passive and active cut-off temperatures. ACTIVE COOLING
activation is only allowed for outside temperatures over the active cooling cut-off
temperature.
The icon indicates that there is a time schedule activated in the COOLING mode.
Cooling buffer
This shows the setpoint temperature of the cooling buffer storage tank and allows
8
3 adjustments to be made to the start-up temperature differential.
Cooling groups
-  +
This can be used to adjust the cooling target outlet temperatures programmed by the
technical service. Each ramp increases or decreased the outlet temperature by 2ºC.
Room terminals
DTc

Used to show and adjust the inside environment temperature setpoint (SetT) and the

 comfort temperature differential (DTc) of the terminals of each outlet unit.


45
User manual ecoGEO