Other Settings; Radio - Kenwood KMM-BT518HD Manual De Instrucciones

HD Radio™ tuner
(for
3 Press the volume knob to display the information related to the message.
4 Press again to exit.
• "NO LIST" appears when the list is empty.
• This feature can store up to four messages in the list.
• To clear the message list, set [FACTORY RESET] to [YES]. ( 5)

Other settings

1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following table), then press
the knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
TUNER SETTING
IF BAND AUTO: Increases the tuner selectivity to reduce interference noises from adjacent
FM stations. (Stereo effect may be lost.) ; WIDE: Subjects to interference noises from
adjacent FM stations, but sound quality will not be degraded and the stereo effect will
remain.
AUTO MEMORY YES: Automatically starts memorizing 6 stations with good reception. ; NO: Cancels.
• Selectable only if [NORMAL] is selected for [PRESET TYPE]. ( 4)
RECEIVE MODE Sets the receive mode of the HD Radio receiver.
AUTO: Automatically tunes to analog broadcast when there is no digital broadcast. ;
DIGITAL: Tunes in to digital broadcast only. ; ANALOG: Tunes in to analog broadcast
only.
CLOCK
TIME SYNC ON: Synchronizes the unit's time to the Radio Broadcast Data System station time. ;
OFF: Cancels.
)
.
Default: XX

RADIO

(for /
Search for a station
1
Press repeatedly to select TUNER.
2 Press repeatedly (or press
the remote control) to select FM1/FM2/FM3/AM.
Press S / T (or press S /
3
control) to search for a station.
• To change the searching method for S / T: Press
repeatedly.
AUTO1 : Automatically search for a station.
AUTO2 : Search for a preset station.
MANUAL : Manually search for a station.
• To store a station: Press and hold one of the number
buttons (1 to 6).
• To select a stored station: Press one of the number buttons
(1 to 6) (or press one of the number buttons (1 to 6) on the
remote control).
Direct Access Tuning
(using the remote control)
1
Press DIRECT to enter Direct Access Tuning.
2
Press the number buttons to enter a frequency.
3
Press to search for a station.
• To cancel, press or DIRECT.
• If no operation is done for 10 seconds after step
Access Tuning is automatically canceled.
/ )
/ on
on the remote
2 , Direct
ENGLISH 7