Kenwood KMM-BT518HD Manual De Instrucciones página 24

BLUETOOTH®
Make a call
You can make a call from the call history, phonebook, or
dialing the number. Call by voice is also possible if your mobile
phone has the feature.
1 Press to enter Bluetooth mode.
"(First device name)" appears.
• If two Bluetooth phones are connected, press
to switch to another phone.
"(Second device name)" appears.
2
Turn the volume knob to select an item (see the
following table), then press the knob.
3 2
Repeat step until the desired item is selected/activated
or follow the instructions stated on the selected item.
4
Press and hold to exit.
To return to the previous setting item, press
CALL HISTORY (Applicable only if the phone supports PBAP.)
1 Press the volume knob to select a name or a phone
number.
• "INCOMING", "OUTGOING", or "MISSED" is shown on
the lower part of the display to indicate the previous
call status.
• Press DISP to change the display category (NUMBER
or NAME).
• "NO DATA" appears if there is no recorded call history.
2 Press the volume knob to call.
20 ENGLISH
PHONE BOOK
again
.
NUMBER DIAL
VOICE
BATT LOW/MID/FULL * : Shows the strength of the battery.
NO SIGNAL/LOW/MID/MAX * : Shows the strength of the current received signal.
* Functionality depends on the type of the phone used.
(Applicable only if the phone supports PBAP.)
1 Turn the volume knob quickly to enter alphabet search mode (if the phonebook
contains many contacts).
The first menu (ABCDEFGHIJK) appears.
• To go to the other menu (LMNOPQRSTUV or WXYZ1*), press J / K.
• To select the desired first letter, turn the volume knob or press S / T,
then press the knob.
Select "1" to search with numbers and select "*" to search with symbols.
2 Turn the volume knob to select a name, then press the knob.
3 Turn the volume knob to select a phone number, then press the knob to call.
• The phonebook of the connected phone is automatically transferred to the unit
when pairing.
• Contacts are categorized as: HOME, OFFICE, MOBILE, OTHER, GENERAL.
• This unit can display only non-accent letters. (Accent letters such as "Ú" is shown
as "U".)
1 Turn the volume knob to select a number (0 to 9) or character ( , #, +).
2 Press S / T to move the entry position.
1 2
Repeat steps and until you finish entering the phone number.
3 Press the volume knob to call.
(or using the remote control)
1 Press the number buttons (0 to 9) to enter the phone number.
2 Press to call.
Speak the name of the contact you want to call or the voice command to control the
phone functions. ( 21, Make a call using voice recognition)