Kenwood KMM-BT518HD Manual De Instrucciones página 9

GETTING STARTED
SYSTEM
KEY BEEP ON: Activates the keypress tone. ; OFF: Deactivates.
SOURCE SELECT
PANDORA SRC (For
ON: Enables PANDORA FRONT/PANDORA REAR/PANDORA in source
selection. ; OFF: Disables. ( 12)
IHEART SRC
(For
ON: Enables IHEARTRADIO-F/ IHEARTRADIO-R/ IHEARTRADIO in source
selection. ; OFF: Disables. ( 13)
BUILT-IN AUX ON: Enables AUX in source selection. ; OFF: Disables. ( 11)
F/W UPDATE
UPDATE SYSTEM/UPDATE HD (for
F/W UP xxxx/ YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not
F/W UP Vxx activated).
For details on how to update the firmware, visit
<www.kenwood.com/cs/ce/>.
FACTORY RESET YES: Resets the settings to default (except the stored station). ;
NO: Cancels.
CLOCK
CLOCK DISPLAY (For
ON: The clock time is shown on the display even when the unit is turned
off. ; OFF: Cancels.
ENGLISH Select the display language for [FUNCTION] menu and music information
if applicable.
ESPANOL
By default, [ENGLISH] is selected.
/ / )
/ / )
)
/ / )
Register the marine remote ID
Applicable only when you connect Kenwood Marine Remote Control unit
(KCA-RC55MR, optional accessory) to this unit.
• For connection, 37, Wiring connection.
• Refer also to the supplied instruction manual of the Kenwood Marine
Remote Control unit for more information.
Preparation:
Press repeatedly to enter STANDBY, then press the volume knob
to enter [FUNCTION].
1
Turn the volume knob to select an item, then press the knob.
[SYSTEM] [REM SETTING] [REMOTE ID SET]
Remote control ID list is displayed.
• [YES] indicates that this ID is already registered.
• [NO] indicates that this ID is available.
2
Turn the volume knob to select an available ID [REM ID1]/
[REM ID2]/[REM ID3], then press the knob.
"REGISTERING" appears on the display window.
To register, on the Kenwood Marine Remote Control unit:
• Press ENTER to register as [REM ID1].
• Press SRC to register as [REM ID2].
• Press DISP to register as [REM ID3].
Once the ID is registered, "COMPLETED" appears.
To delete the registered ID
1
Turn the volume knob to select an item, then press the knob.
[SYSTEM] [REM SETTING] [REMOTE ID DEL]
2
Turn the volume knob to select the ID to delete [ID1 DELETE]/
[ID2 DELETE]/[ID3 DELETE], then press the knob.
3 Turn the volume knob to select [YES] to delete the selected ID, and
select [NO] to cancel.
• To exit, press and hold .
• To return to the previous setting item, press
(for )
.
ENGLISH 5