Dexter 900BS2.5 Manual De Instrucciones página 148

FR
5. BEFORE PUTTING THE EQUIPMENT INTO OPERATION
ES
PT
Grit
60 or less
IT
80 – 100
EL
120 – 150
180 – 220
PL
240 or more
UA
Attaching a sanding belt
RO
Always ensure that the machine is switched o and plug is removed from the power
point before making any adjustment.
EN
1. Select the required grade of sanding belt.
2. Pull the belt tension lever.
3. Slip a sanding belt into position with the arrow on the inside of the belt pointing in the
same direction as the rotation indicator on the sander.
4.
Fold down the lever.
WARNING: Do not continue to use the sander with a sanding belt that
is overworn or damaged.
WARNING: Do not use the same sanding belt for wood and metal.
Metal particles become embedded in the belt and will scour a
wooden surface.
WARNING: Clean the air vents on your power tool regularly. The
motor's fan will draw the dust inside the housing and excessive
accumulation of powdered metal may cause electrical hazards.
Adjusting sanding belt tracking
WARNING: For your safety, before plugging the tool into a power
point, ensure that the trigger switch is set to the "o "position.
148
GRIT CHART
Type Example of use
Material removal, heavy paint removal,
Very Coarse
shaping wood
Paint removal, rough surface preparation
Coarse
(e.g. non-planed wood)
Medium Surface preparation planed wood
Sanding between coats
Fine
Very Fine
Final finishing