In Case Of Power Failure Or Paper Jam; Program Resetting; Before Calling For Service - Sharp ER-A160 Manual De Instrucciones

In case of power failure or paper jam

8
When power is lost, the machine retains its memory contents and all information on sales entries.
The following situations occur during a power failure or paper jam. (Batteries must be correctly installed.)
When a power failure occurs when the register is turned on or during a computation process:
When power returns, the register resumes operation from the point of failure.
When a power failure occurs during the printing of a sales transaction or of X/Z
reports:
When power returns, the register prints "
printing of the transaction or reports.
What to do when the printer motor locks:
If the printer motor happens to lock, the printing stalls, and an intermittent beeping
starts. If this occurs, please follow the procedure below.
1.
Turn the mode switch to "
2.
Insure the printer is clear of any obstructions (e.g. paper jams, etc).
To clear the printer, remove the printer cover and the ribbon cover.
3.
Turn the mode switch to the previous position. The "----------" appears in the display.
4.
Feed the paper roll to the proper position.
c
5.
Press the key.
6.
The register will resume correct printing after printing "

Program resetting

9
If your register is locked, perform the program resetting. When the program resetting is performed, the register
returns to the initial state without erasing the sales data and user-programmed settings. The procedure is as
follows:
1.
Unplug the power code from the outlet.
2.
Turn the mode switch to " PGM " position.
á
3.
While pressing the
When the program resetting is done successfully, "

Before calling for service

10
The malfunctions shown in the left-hand column below, labelled "Fault," do not necessarily indicate functional
faults of the machine. It is therefore advisable to refer to the "Checking" shown in the right-hand column before
calling for service.
(1) The display shows symbols that do not make sense.
(2) The display won't be illuminated even when
the mode switch is turned to any other
position than " ".
(3) The display is illuminated, but the whole machine
refuses registrations.
(4) No receipt is issued.
(5) No journal paper is taken up.
(6) Printing is unusual.
" position.
key, plug the power code to the outlet.
Fault
" and then resumes correct
".
2" is printed.
• Was the machine initialized?
• Is power supplied to the electrical outlet?
• Is the power cord plug out or loosely connected to the
electrical outlet?
• Is a cashier code assigned to the register?
• Is the mode switch set properly at the "REG" position?
• Is the paper roll properly installed?
• Is there a paper jam?
• Is the receipt function in the "OFF" status?
• Is the take-up spool installed on the bearing properly?
• Is there a paper jam?
• Is the paper roll properly installed?
• Is the ink ribbon worn out?
• Is the ink ribbon installed properly?
• Has the ink ribbon folded?
Checking
43