Tabla de contenido
Publicidad
OPERATOR MAINTENANCE
In case of Power Failure
1
When power is lost, the machine retains its memory contents and all information on sales entries.
• When a power failure is encountered in register idle state or during an entry,
the machine returns to normal operation after power recovery.
• When a power failure is encountered during a printing cycle, the register prints
"============" and then carries out the correct printing procedure after
power recovery. (See the sample print.)
In Case of Printer Error
2
If the printer runs out of paper, the printer will stall, and "PAPER EMPTY" will appear on the display. Key entries
will not be accepted. Refer to section 4 in this chapter, install a new roll, then press the
print the power failure symbol and resume printing.
If the print head comes up, the printer stalls, "HEAD UP" will appear on the display. Key entries will not be
accepted. Bring the print head back to the correct position, then press the
power failure symbol and resume printing.
3
Cautions in Handling the Printer and Recording Paper
Cautions in handling the printer
• If you are not going to use the register for an extended period of time,
pull the print head release lever toward you so that the print head is
set apart from the plate. (head-up position)
• Avoid dusty and humid environments, direct sunlight and iron powder
(a permanent magnet and electromagnet are used in this machine.)
• Use the print head release lever only when necessary.
• Never pull the paper when it is in contact with the print head. First
release the head with the print head release lever, and then remove
the paper.
• Never touch the surface of the print head.
• Never touch around the print head and the motor during printing or before they have had sufficient time to cool.
Cautions in handling the recording paper (thermal paper)
• Use only paper specified by SHARP.
• Do not unpack the thermal paper until you are ready to use it.
• Avoid heat. The paper will color at around 70°C.
• Avoid dusty and humid storage places. Avoid direct sunlight.
• The printed text on the paper can discolor under conditions of high humidity and temperature, exposure to
direct sunlight, contact with glue, thinner or a freshly copied blueprint, and heat caused by friction from
scratching or other means.
• Be very careful when handling the thermal paper. If you want to keep a permanent record, copy the printed text
with a photocopier.
74
l
key. The printer will
l
key. The printer will print the
Printing position
Head-up position
Publicidad
Capítulos
Tabla de contenido
