Installation; Vertical Installation And Wall Mounted Installation - Citizen CD-S500 Serie Manual Del Usuario

Installation

This printer can be installed horizontally or vertically and can be wall mounted.
But according to the model you are using, there may be restrictions on how it is installed.
Refer to the following table.
Standard model (AC adapter type)
Standard model (Built-in AC adapter type)
Auto cutter equipped model (AC adapter type)
Auto cutter equipped model (Built-in AC adapter type)
Auto cutter and rewinder equipped model
(AC adapter type)
Auto cutter and rewinder equipped model
(Built-in AC adapter type)
1
* : Accessory rubber feet must be used to prevent slipping.
* 2 : The optional specialized wall mount unit is necessary to mount it on the wall.

Vertical installation and wall mounted installation

To install the printer vertically or wall mounted, remove the Chassis Platen L Spring used to
open the rear cover. And reverse the LED name sheet on the operation panel to use it with
the vertically installed and wall mounted display.
Removing the Chassis Platen L Spring
1
. Open the rear cover. Do this carefully, because
the cover snaps open vigorously.
2
. Lift part A with the fingers of your right hand.
3
. Switch the Chassis Platen L Spring that you have
raised from your right thumb to your left thumb
to hook the protrusion on the end of the Chassis
Platen L Spring inside part B of the printer.
Caution
Chassis Platen L Spring with strong
repulsive force is used. Be very careful
that it does not slip off your finger
causing an injury.
LED Name Sheet
Remove and reverse the sheet then reinsert the
protruding part of the center of the sheet in the
printer and push in both ends.
Horizontal Vertical
Yes No
Yes Yes* 1
Yes No
1
Yes Yes*
Yes No
Yes No
English
Wall Mount
Yes* 2
Yes* 2
Yes* 2
2
Yes*
No
No
Chassis
Platen
Part A
L Spring
Protrusion
Part B
23