Citizen CD-S500 Serie Manual Del Usuario página 38

Chapter4 Maintenance Mode
Soft SW Setting Mode
Operating method
Press the FEED switch (less than 2 seconds):
The setting changes.
The present set value is changed and the
same item is reprinted. (Press the FEED
switch, and when the buzzer sounds once,
release it.)
Pressing the FEED switch continuously (2
seconds or more):
Moves to the next item.
It prints the present set value of the next
item. (Press the FEED switch, and when the
buzzer sounds three times, release it.)
Opening/closing the front cover:
After saving the set values, it reprints all
items from the top and returns to normal
power on status.
* If the power is turned off without opening
and closing the front cover, the setting
change is invalid.
* If the paper runs out during the change,
set the paper and close the rear cover to
continue the process.
36
<Soft-Switch Setting>
Press Feed
Press Feed For 2S
F.Cover Open/Close
<Soft Control-SW>--------------------
Command Type
Number of Col.
Font Select
Paper Plies
Paper End
Paper Near-End
Slashed Zero
Print Direct.
Auto LF
Code Page
Buffer Size
Init Signal
Buzzer
<Interface-SW>------------------------
Baud Rate
Data Length
Parity Bit
Stop Bit
Protocol
<Mechanical-SW>--------------------
Paper Width
Auto-Cutter
Color Ribbon
Take-Up Device
Black Mark
Command Type
Operations
Press the
FEED Switch
Command Type
Press and
hold the FEED
Switch
Number of Col.
Press and
hold the FEED
Switch
Font Select
Press the
FEED Switch
Font Select
Example of a change of the Command Type to
STAR and the Font Select to 9×9.
Change PARM.
Next Item
Save & Exit
—EPSON
—40/33
—7 × 9
—OFF
—ENB
—ENB
—OFF
—BI-DIR
—OFF
—437
—4K
—ENB
—ON
—9600
—8bit
—NONE
—1bit
—DTR
—76.2
—PAR.
—ON
—ON
—DIS
—EPSON
—STAR
—40/33
—7 × 9
—9 × 9