Snap-On John Bean MH 310 PRO Manual De Operador página 20

MH 310 PRO
MH 320 PRO
20
3.1-5
3.1-6
3.1-7
Introduction
(Fig. 3.1-5)
Lubricant Bottle Support
- cod.: EAA0329G65A
Holds the lubricant bottle at the base of the bead
presser device. Use for the bottle supplied with the
tire changer, if present. The Kit does not include the
Lubricant bottle.
(Fig. 3.1-6)
Repositioning the Filter/Lubricant Support unit
- code: EAA0329G64A
If fi tting the bead presser on the machine means
limiting access to the tyre changer Filter – Lubricating
unit, this Kit allows you to move the unit to the back of
the bead presser, where it is easily accessible.
When the unit has been moved the air-hoses going
into the tyre changer may seem short, therefore, new
longer hoses which can be cut to size are supplied, to
replace the original ones.
Note: If the bead presser is already fi tted with
the fi lter support as shown in Fig. 3.1-7,
the KIT is not needed and the longer
hoses are already present from the bead
presser.
Operator's Manual