Testing Procedures - Snap-On John Bean MH 310 PRO Manual De Operador

MH 310 PRO
MH 320 PRO
44
iii-7
Appendix
Compressed air connection Compressed air connection
(fi g. iii-7) (fi g. iii-7)
THE COMPRESSED AIR SUPPLY MUST BE THE COMPRESSED AIR SUPPLY MUST BE
CONNECTED UP BY SPECIALISED PERSONNEL. CONNECTED UP BY SPECIALISED PERSONNEL.
Check that the line pressure is within the limits required Check that the line pressure is within the limits required
by the machine. by the machine.
If the air pressure is lower than the minimum required If the air pressure is lower than the minimum required
of 110 psi (8 bar) the force of the device may be of 8 bar (110 psi) the force of the device may be
insuffi cient for certain types of tyres. insuffi cient for certain types of tyres.
After checking all the above proceed as follows:
• Remove the left-hand side panel.
• Inside the casing, cut the air hose extending from
the fi lter or supply block (1, Fig. iii-7) to the pedals.
• Insert the connector (2, Fig. iii-7) in the cut hose
and connect the device air hose (3, Fig. iii-7) to it,
passing into the casing through one of the free holes
close to the fi lter.
• Replace the tyre changer side panel.
iv. Testing procedures
Not fi tted to this machine.
v. Instructing the operator
(Following applies only if a unit is installed by a service
Technician)
• Show the operator the fi rst use of the equipment.
Operator's Manual