Commissioning; Putting The Unit Into Operation; Automatic Mode; Manual Operation - Dentsply Sirona inLab MC X5 Instrucciones De Uso

Dentsply Sirona
Operating Instructions Suction devices for inLab MC X5 and
64 98 609 D3608
D3608.201.02.04.02 09.2017
5

Commissioning

5.1

Putting the unit into operation

5.1.1

Automatic mode

✔
The interface cable is connected.
➢ Set the on/off switch to the position Auto.
Note on the automatic mode:
The processing machine monitors the correct socket (interface cable and
suction tube) and the operation of the suction system during the running
processes.
5.1.2

Manual operation

NOTICE
Manual mode only permitted for inLab MC X5. For CEREC MC/MC X/
MC XL Premium Package only automatic mode is supported.
1. Prior to commencing processing, set the on/off switch to the On
position.
2. Once processing has been completed, set the on/off switch to the
Off position.
5.1.3

Setting the suction power

inLab MC X5
➢ Set the suction power to the maximum (max).
CEREC MC/MC X/MC XL Premium Package
➢ Set the suction power to the minimum (min). If required, the suction
power can be set to the maximum.
5.2

Repacking

1. Set the on/off switch to the position Off.
2. Remove the power plug, interface cable, and suction tube.
3. Check the suction device for completeness according to the scope of
supply.
4. Pack the device safely, ideally in the original transport packaging.
5 Commissioning
17