Cleaning And Maintenance; Cleaning The Unit - Bartscher Panini 1RDIG Manual De Instrucciones Originales

3. Set required time in the range from 1 second to 99:59 minutes.
4. Press the Start/Stop button (7) to switch on the timer.
5. Press the Start/Stop button (7) to switch off the timer.
After the set time has expired the acoustic signal sounds and the display shows End1.
End1 means the end of program 1.
6. Cancel the acoustic signal and digital display (5) indications with the Start / Stop
button (7).

6. Cleaning and maintenance

WARNING!
Risk of short-circuit due to presence of liquids!
Liquids in the device may cause short-circuit.

Do not allow any liquids to enter into the device.
The device is not designed for flushing with direct water jet. Do not clean the device with
use of water jet!
NOTE
Incorrect use may cause damage.

For cleaning the device, use a soft cloth only, never use aggressive cleaning
agents or coarse brushes.

Clean the device after each use.

6.1. Cleaning the unit

1. Turn the temperature controller knob (3) anti-clockwise to its 0 position.
2. Set the ON/OFF switch to its O position. The device is switched off and the green
power indicator light in the ON/OFF switch is not lit.
3. Pull the plug from the socket.
4. Leave the device to cool down completely.
5. Clean the outside of the casing (12) and operating handle (13) with a damp cloth.
6. In case of more stubborn soiling you can use mild detergent.
7. Open the device with the operating handle (13) and lift the upper grill plate.
8. Clean the grill plates (9, 11) with warm water and mild detergent and a soft cloth.
- 33 -