Programming Example - Dal Zotto BEATRICE Manual Del Usuario

PROGRAMMING EXAMPLE

Let's suppose that the weekly Programmer function is to be used and 4 time slots are to be used in the following way:
- 1st time slot: from 08:00 to 12:00 every day of the week, with room temperature at 19°C, excluding Saturday and Sunday
- 2nd time slot: from 15:00 to 22:00 only on Saturday and Sunday, with room temperature at 21°C
CONTROLS PROCEDURE:
Press key 6 and SET CLOCK will appear.
Press key 2 until enable chrono appears
Enable the chrono
Enable slot 1 and 2.
Press key 1 to exit
* Where "ENABLE CHRONO" is not present
in the menu, enabling is done directly in
SET CHRONO.
CONTROLS PROCEDURE:
Press key 2 and SET CHRONO will appear.
Press key 6 to con rm and continue
programming.
START PRG1 OFF will appear.
1ST TIME SLOT SWITCH ON
Use keys 4 - 5 to enter the time "08:00",
which corresponds to the switch-on time of
the 1st time slot.
To con rm and continue programming,
press button 6. Press button 3 to go back to
the previous parameter.
*2ND TIME SLOT SWITCH ON
At this point, the second time slot must be programmed.
The sequence to be followed is the same and is repeated as per the 1ST TIME SLOT SWITCH ON.
On this occasion simply enter the time, for example start at 15:00 and Stop at 22:00 and to activate the days Saturday and Sunday by setting
them at "ON".
WHEN THE WEEKLY PROGRAMMER IS ACTIVE, A BOX OF THE RELATIVE ICON WILL APPEAR ON THE
CONTROL BOARD.
1ST TIME SLOT SWITCH OFF
SET
CLOCK
Use keys 4 - 5 to enter the time "12:00",
which corresponds to the switch-o time of
the 1st time slot.
To con rm and continue programming,
press button 6. Press button 3 to go back to
ENABLE
the previous parameter.
CHRONO
ENABLING THE 1ST TIME SLOT DAYS
To enable/ disable the days use keys 4 and
5; key 2 and 3 to scroll the various days, the
SET CHRONO
day of the week will appear, followed by
OFF
select from Monday to Friday on ON,
excluding Saturday and Sunday (OFF)
1ST TIME SLOT TEMPERATURE SETTING
Press key 6 to con rm and continue
START PRG1
programming.
OFF
Using buttons 4 - 5 select the desired
temperature.
(Low -07 - 40°C Hot)
To con rm and proceed press key 6.
2ND TIME SLOT SWITCH ON*
At this point, the second time slot must be
programmed.
START PRG1
08:00
The sequence to be followed is the same
and is repeated as per the 1ST TIME SLOT
SWITCH ON.
ENGLISH
STOP PRG1
12:00
MONDAY..PRG1
ON OFF
SET PRG1
19°C
START PRG2
OFF
55