JVC SP-DW103 Manual De Instrucciones página 8

Connections
Checking Your Amplifier
Before connecting this unit to your amplifier (or receiver), check
what types of connecting terminals your amplifier has.
Follow the instructions below to find a proper connection method
for your equipment.
• Illustrations of jacks and terminals in this manual may be
different from the ones actually used for your amplifier. The
illustrations are of the most used type.
First check whether your amplifier has a subwoofer output
jack.
It is usually named and printed as the "SUBWOOFER OUT" or
"SUBWOOFER."
If you find it on your amplifier, follow Connecting Method Å.
If you cannot
find any
Next check whether your amplifier has line output jacks.
They are usually named and printed as "LINE OUT" or "LINE
OUTPUT."
If you find them on your amplifier, follow Connecting Method ı.
If you cannot
find any
Follow Connecting Method Ç.
This connection can be used for any amplifier, by connecting the
front speaker terminals of the amplifier (usually named and
printed as "FRONT SPEAKERS" or "MAIN SPEAKERS").
Before connecting this unit to the amplifier (or receiver),
observe the following carefully.
• Before connecting this unit to an amplifier, turn off the
amplifier first.
• Make all connections before plugging in this unit.
• DO NOT use the INPUT 1 (LOW-LEVEL) and INPUT 2
(HIGH-LEVEL) terminals on the rear of this unit at the
same time; otherwise, noise will be heard and may
damage the unit.
• DO NOT connect this unit to the REC OUT jacks of your
amplifier.
Connecting to the Amplifier
SUBWOOFER
OUT
When connecting to your amplifier (or receiver), refer also the
manual supplied for your equipment.
Connecting Method Å
Connect an amplifier having a subwoofer output jack to the
LEFT/MONO jack of the INPUT 1 (LOW-LEVEL) terminal.
Preparation:
Use the supplied monaural
audio cord.
LINE OUT
L
R
FRONT SPEAKERS
1
2
RIGHT LEFT
When using Connecting Method Å, no signal comes out of
the TO MAIN SPEAKERS terminal.
– 1 –
Main (Front) Speakers
(not supplied)
Your Amplifier
VOLUME FREQUENCY
MIN 50Hz
MAX 200Hz
PHASE CUT OFF FILTER
NORMAL VARIABLE
REVERSE FIXED
AUTO POWER ON/STANDBY
RIGHT LEFT/MONO
ON
INPUT 1
CANCEL
(LOW-LEVEL)
RIGHT
RIGHT LEFT
INPUT 2
(HIGH-LEVEL)
TO MAIN
SPEAKERS
RIGHT LEFT
POWER
OFF ON
SP-DW103 To an AC outlet
SUBWOOFER
OUT
Monaural audio cord
(supplied)
LEFT/MONO
INPUT 1
(LOW-LEVEL)