Additional Information; Troubleshooting - JVC SP-DW103 Manual De Instrucciones

Ocultar thumbs Ver también para SP-DW103:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Additional Information

Speaker layout
To obtain the best possible sound from your unit:
—Place a subwoofer wherever you like since bass sound is non-
directional. Normally place it in front of you.
—Place all the main speakers at the same distance from the
listening position.

Troubleshooting

Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact your dealer.
Symptom
Power does not come on.
Auto Power On/Standby does not function
correctly.
No sound is heard.
Sounds fluctuate (suddenly become loud
or soft).
Suddenly no sound comes out.
—the power lamp lights in red.
Suddenly no sound comes out.
—the power lamp still lights in green.
Specifications
Possible Cause
Is the unit pugged in?
Signals are too weak or volume level is
too low.
Is the VOLUME knob turned to the MIN
position?
Connections are incorrect, or loose.
Audio signals through the amplifier are
extremely weak.
The built-in protective circuit is working.
The VOLUME knob on the rear is set to
a very high level.
The volume of the playback source is too
high.
Type :
Speaker unit :
Frequency range :
Input impedance :
Input terminals :
Power requirements :
Output power of built-in amp :
Power consumption :
Dimensions :
Mass :
Accessories :
Left front
speaker
Left surround
speaker
Plug the AC power cord firmly into the AC
outlet.
This is not a malfunction. If this happens,
cancel Auto Power On/Standby.
Turn the VOLUME knob until a suitable volume
is found.
Check the connections. If incorrect, redo the
corrections. (See pages 1 and 2.)
Increase the volume level on the amplifier.
Lower the volume level on the amplifier so that
the symptom will not occur.
Turn down the volume, then turn off and on
this unit.
Turn down the volume of the playback source,
turn off and on the source, then adjust the
volume properly on the source.
Powered Subwoofer
Bass-reflex type, (magnetically shielded type)
16.0 cm cone (× 1)
30 Hz to 200 Hz
50 kΩ (LOW-LEVEL)
470 Ω (HIGH-LEVEL)
INPUT 1 (LOW-LEVEL)
INPUT 2 (HIGH-LEVEL)
AC 110 V–240 V
, 50 Hz/60 Hz
100 W (45 Hz, 4 Ω, 10 % THD)
27 W
210 mm (width) × 392 mm (height) × 348 mm (depth)
10 kg
Monaural audio cord (× 1)
AC plug adaptor (× 1)
– 5–
Subwoofer
Right front
speaker
Center
speaker
Listening position
Right surround
speaker
Action

Publicidad

Tabla de contenido
loading

Tabla de contenido