Turning On The Device; Turning Off The Device; Selecting The Treatment Time - Beurer EM 39 Manual De Instrucciones

4. If your back pain is in the lower treatment area, position the belt so that the middle of the belt
sits approximately 1 to 2 inches below the waist.
5. When the belt has been maneuvered into the correct position, bring the two ends of the neo-
prene straps together and fasten with the built-in hook and loop pads.
6. The belt may be tightened or loosened as shown by adjusting the hook and loop closure (See
diagram below).

6.2 Turning On the Device

Press and hold the "ON +" button [10]* for approximately one (1) second to turn on the device.
The most recently selected treatment time and program will flash when the unit is turned on.

6.3 Turning Off the Device

The device turns off automatically after the therapy session time has elapsed.
To turn the unit off manually, press the "OFF -" button [12]* for three (3) seconds.
The display will be blank and the device will turn off.
In an emergency you may also pull the connector(s) from the device and then remove the belt.
* page 7

6.4 Selecting the Treatment Time

Press MODE [15]*. The preset (default) treatment time will flash on the display.
To increase or decrease the treatment time, press the button "ON +" (to increase) or the button
"OFF -" (to decrease) repeatedly until the desired duration appears on the display.
Press MODE [15] again to save your selection. The treatment time you selected will appear on the
display the next time you turn the device on.
Note:
If you change programs during the course of a therapy session, the treatment time will not reset
unless you manually reset it by performing the steps described above.
* page 7
10