Disposal; Technical Specifications - Beurer EM 39 Manual De Instrucciones

Unit
The device does not need any special maintenance.
Remove the battery before cleaning the device.
Clean the device with a soft, slightly moistened cloth.
Remove the battery if the device is not used for a week or more.
Store the unit with the belt in a clean, dry place.
Belt
Always detach the TENS unit from the belt after use.
If the belt has become damp during use, let it dry naturally before using again.
The belt maybe cleaned using a lightly dampened sponge. Lay the belt out flat or hang it up to
dry naturally.
Ensure the belt is completely dry before using it again.

9. Disposal

NOTICE:
• Follow all laws and regulations regarding the proper disposal of batteries and electronic
devices that are relevant in your area. Consult your municipal authorities or your dealer
for information about proper disposal.

10. Technical Specifications

Channels
Pulse Intensity
Output Voltage
Frequency
Pulse Width
Curve Shape
Programs
Belt size for waist sizes from
Power Supply
Operating Conditions
Storage Conditions
Key to symbols
Dual
Adjustable 0 – 80 mA peak into 500 ohm load each channel
40 V (at 0.5 k)
50 V (at 1 k)
60 V (at 2 k)
2 – 60 Hz
156 – 260 μs
Symmetrical biphasical wave form
8
24" to 60" (61 to 152 cm)
3 x 1.5 V AAA batteries
32 °F to 104 °F (0 °C to 40 °C), 20 to 90% relative humidity
14 °F to 140 °F (-10 °C to 60 °C), 20 to 93% relative humidity
WARNING! Read the safety information and all
instructions to avoid serious injury.
14