Care And Maintenance - Beurer EM 39 Manual De Instrucciones

Defect
The device does not turn
on.
The device turns on and
then off again.
The device turns on, but
does not generate electric
pulses.
The unit does not turn on
even though new batteries
have been inserted.

8. Care and Maintenance

WARNING:
• Use the unit only with the supplied accessory.
CAUTION:
• Do not attempt to disassemble, open and/or repair the device yourself in the event of
a malfunction. You could get injured. Moreover this will invalidate the warranty.
• Do not use the control unit and belt again until they are completely dry.
• Do not pull on the cables but on the connectors attached to the ends of the cables in
order to detach the TENS control unit from the belt.
NOTICE:
• Protect the device from moisture. If liquid should get into the device, remove the battery
immediately and discontinue use. Should this happen, contact our customer service.
• Follow all laws and regulations regarding the proper disposal of batteries and electronic
devices that are relevant in your area. Consult your municipal authorities or your dealer
for information about proper disposal.
• Never use aggressive cleaning products or stiff brushes to clean the device.
• Do not allow water to penetrate the device.
• Do not expose the device to direct sunlight and protect it from dirt and moisture.
• Do not wash the belt in water. Do not wash the belt in the washing machine. Do not
tumble dry.
• Do not use bleach when washing the belt.
• Do not dry clean your belt. Do not dry it over anything hot (e. g. a radiator) as it con-
tains plastic parts.
• The belt should never be ironed.
• The cables are integrated into the belt. Do not pull on the cables!
Cause
No battery or bad battery.
Battery not inserted properly.
Battery life expired.
Cable not connected properly,
Treatment time has expired.
Therapy Intensity level has not
been set.
Cable broken.
13
Remedy
Replace battery.
Insert battery again.
Replace battery.
Replace battery.
Connect cable properly. Switch
unit to the OFF position and turn it
back on.
See section "6.6 Selecting the Ther-
apy Intensity Level".
Contact customer Service.
Contact customer Service.