Citizen CT-S4500 Manual De Usuario página 35

3. For supplying power
Connect a mobile device or other USB device.
Power can be supplied to a connected USB device.
* This port does not support USB data communication.
Names of parts
1. Panel button
Control this interface board.
2. USB 2 port
Connect a peripheral device.
CAUTION
 Only connect peripheral devices specified by our company to the USB port.
 Only plug in/remove peripheral devices when the printer power is turned off.
Pairing operation
You need to perform the operations below the first time you establish a Bluetooth con-
nection for Bluetooth data communication.
1. Detect Bluetooth devices
2. Configure pairing settings
1. Detecting Bluetooth devices
Confirm that Bluetooth is enabled on the host PC before searching for Bluetooth
devices.
This product will show up as "CT-S4500_XX"(XX is last 2 digits of unique BD
address.) when it is detected.
Select this product from among the detected devices.
Note: You can search for devices and change the names.
When memory switch MSW13-5 is set to "No Response," nothing is displayed by
device detection.
With these settings, pressing and holding the panel button for at least three
seconds and then pressing it twice more places the product temporarily in a state
where it will be found in device searching (discovery mode).
Discovery mode cancels when the product is connected to a host PC.
Refer to 3.7 USB Power Supply Port
1 2
35
— —