Manual Setting Of Memory Switches - Citizen CT-S4500 Manual De Usuario

5.3 Manual Setting of Memory Switches

Memory switches are used to set various printer settings. Memory switches can be set
manually, or by utilities or commands. This section explains how to perform manual
settings.
For information on how to set the memory switches using commands, please refer to
the Command Reference.
Individual setting mode
Set the memory switches individually.
Do the settings while confirming the memory switch function and settings on the print-
out.
1. Load paper.
2. With the top cover open, turn on the printer power while pressing and holding the
FEED key.
3. Press the FEED button twice and close the paper cover.
The printer enters the mode for setting memory switches individually.
The printer prints "Memory SW (1)" and the current setting, 0 (off) or 1 (on).
(The current settings for memory switches 7 to 13 are not printed.)
Current memory switch
4. Press the FEED button.
Each press of the FEED button cycles through the list of memory switches in the following
sequence: "Memory SW (1)" > "Memory SW (2)" > ..."Memory SW (11)" or "Memory SW (13)"
> "Save To Memory" > "Memory SW (1)".
Press the FEED button until the number for the memory switch you want to change is printed.
5. Press the FEED button for at least two seconds.
A setting for the memory switch is printed, through the cycle, each time the FEED button is
pressed for at least two seconds.
Press the FEED button for at least two seconds to cycle through the list until the function of
the memory switch you want to change is printed.
Memory switch function
Current setting
Current setting
78
— —