Names Of Parts - PIONEER DJ DDJ-400 Manual De Instrucciones

Step 2 Connecting devices and this unit

Names of Parts

For details, see the "Operating Instructions" of this unit.
MIC input terminal (1/4" TS jack)
*Supported unbalanced input only
MASTER output
terminals
USB terminal
BEAT SYNC button
CUE/LOOP CALL button
RELOOP/EXIT button
OUT (OUT ADJUST)
button
IN/4BEAT
(IN ADJUST)
button
Jog wheel
SHIFT button
HEADPHONES MIXING
control
Pad mode select button
CUE button
HEADPHONES LEVEL control
PLAY/PAUSE f button
Performance pad
TEMPO slider
Connecting speakers with a built-in
amplifier to the unit with an audio
cable (RCA)
Connect speakers with built-in amplifier, etc. to the
[MASTER] output terminals of this unit.
• An audio cable (RCA) is not included with this unit. Please provide it
yourself separately.
Speakers with built-in amplifier,
etc.
• For details on connecting the input/output terminals, see the
"Operating Instructions" of this unit.
• Turn the volume of the device(s) (speakers with built-in amplifier, etc.)
connected to the [MASTER] output terminals to an appropriate level.
Note that the output sound may be loud if the volume is set too high.
MIC LEVEL control *When not using a microphone, turn the volume to the minimum level.
Deck 1
(left)
Connecting your PC/Mac to the unit
1 Connect your PC/Mac to the unit via a USB cable.
Make a direct connection with the supplied USB cable for optimum
performance. A USB hub cannot be used.
2 Turn on your PC/Mac.
3 Turn on the device(s) (speakers with built-in
amplifier, etc.) connected to the output terminal.
LOAD button
Rotary selector
TRIM control
EQ (HI/MID/LOW) controls
MASTER LEVEL control
Headphones CUE button (MASTER)
CHANNEL LEVEL indicator
BEAT,  buttons
FILTER control
BEAT FX SELECT button
BEAT FX CH SELECT switch
BEAT FX LEVEL/DEPTH control
Headphones CUE button (CH)
BEAT FX ON/OFF button
Channel fader
Crossfader
Deck 2
(right)
PHONES output terminal
(3.5 mm stereo mini jack)
USB cable (supplied)
PC/Mac
7
En