In any case, consult your responsible Master
Chimney Sweep. He is able to assess the
house's entire ventilation setup and will
suggest the suitable ventilation measures to
you.
Unrestricted operation is possible if the vapour
extractor hood is operated exclusively in the
circulating-air mode.
Risk of fire!
Grease deposits in the grease filter may
▯
catch fire.
Clean the grease filter at least every
2 months.
Never operate the appliance without the
grease filter.
Risk of fire!
Grease deposits in the grease filter may
▯
catch fire. Never work with naked flames
close to the appliance (e.g. flambéing). Do
not install the appliance near a heat-
producing appliance for solid fuel (e.g.
wood or coal) unless a closed, non-
removable cover is available. There must
be no flying sparks.
Risk of fire!
Hot oil and fat can ignite very quickly.
▯
Never leave hot fat or oil unattended. Never
use water to put out burning oil or fat.
Switch off the hotplate. Extinguish flames
carefully using a lid, fire blanket or
something similar.
Risk of fire!
The grease deposits in the grease filter
▯
may ignite. If the appliance operates
beside a gas-fired appliance, a ventilation
moulding must be attached when cooking.
The ventilation moulding improves the
extraction behaviour for gas-fired
appliances. The ventilation moulding
prevents small flames from going out as a
result of a draft.
Risk of burns!
The accessible parts become very hot when in
operation. Never touch hot parts. Keep
children at a safe distance.
Risk of injury!
Components inside the appliance may have
sharp edges. Wear protective gloves.
Risk of electric shock!
A defective appliance may cause electric
▯
shock. Never switch on a defective
appliance. Unplug the appliance from the
mains or switch off the circuit breaker in
the fuse box. Contact the after-sales
service.
Risk of electric shock!
Incorrect repairs are dangerous. Repairs
▯
may only be carried out and damaged
power cables replaced by one of our
trained after-sales technicians. If the
appliance is defective, unplug the
appliance from the mains or switch off the
circuit breaker in the fuse box. Contact the
after-sales service.
Risk of electric shock!
Penetrating moisture may cause an electric
▯
shock. Do not use any high-pressure
cleaners or steam cleaners.
Causes of damage
Risk of damage due to ingress of humidity into the
electronic circuitry. Never clean operator controls with
a wet cloth.
Surface damage due to incorrect cleaning. Clean
stainless steel surfaces in the direction of the grain
only. Do not use any stainless steel cleaners for
operator controls.
Surface damage due to strong or abrasive cleaning
agents. Never use strong and abrasive cleaning
agents.
5