Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3.10
Calibrating the Paper Sensor
Calibrate the paper sensor to suit the actual paper you are using before using
label paper or black mark paper.
When you perform the procedure below, the printer will automatically feed the
paper loaded in it and set the sensor to the optimum sensitivity. Or, the paper
type is automatically selected.
To load label paper
1.
Turn off the power.
2.
Pull the cover open lever forward and open the paper cover.
3.
Press in on the paper damper in the direction indicated by the arrow until it clicks.
4.
Peel off the first label of the label paper.
Peel off a few labels, if they are short, so at least 5 cm of paper is uncovered.
5.
Load the paper roll so that the printable side of the paper is facing down.
6.
Adjust the paper position so the part from which you peeled the label is located
above the label sensor.
Label sensor
7.
Close the paper cover.
Paper damper
Label
— 31 —
Roll paper
Label guide
Publicidad
Capítulos
Tabla de contenido
