Citizen CT-S801 Manual De Usuario página 58

Switch no.
MSW10-1 Print Density
MSW10-2 Print Speed
MSW10-3 ACK Timing
8 Emulation Type
* MSW10-4
MSW10-5
MSW10-6 Buzzer Sound
MSW10-7
MSW10-8 LCD Direction
Notes:
*1: If print data is very dense, the print head is hot, data transmission is slow, or some other
conditions, the motor and printing may occasionally stop which causes white stripes in the
printout. To print high-density data, set MSW2-3 (Spool Print) to ON to reduce striping, although
this increases the time before printing starts.
For a serial interface, increase the transmission speed to prevent the motor from stopping.
*2: Label printing
*3: Black mark model
*4: MSW4-8 cannot be used in the case of black mark paper.
MSW2-8 and MSW4-8 cannot be used in the case of label paper.
*5: The values for memory switches MSW7-X are only effective when DIP switch no. 1 is set to OFF .
*6: Enabled for firmware version Dxxx-2500 and later.
*7: Enabled for firmware version Dxxx-2300 and later.
*8: Enabled for firmware version Dxxx-2200 and later.
Function Initial setting
100 %
Level 9
Before Busy Before Busy, Same Period, After Busy
ESC/POS
Reserved
Tone 2
Key Lock Invalid
Normal
70 %, 75 %, 80 %, 85 %, 90 %, 95 %, 100 %, 105 %,
110 %, 115 %, 120 %, 125 %, 130 %, 135 %, 140 %
Level 1, Level 2, Level 3, Level 4, Level 5, Level 6,
Level 7 , Level 8, Level 9
ESC/POS, CBM1, CBM2
Tone 1, Tone 2, Tone 3, Tone 4
Invalid, Valid
Normal, Inverted
— 54 —
Setting value