Power Supply Cord Connection - Sears Kenmore 110.81422 Manual De Uso Y Cuidado

Power Supply Cord Connection

1.
Attach power supply cord
strain relief
Remove the screws from a 3/4" (19 mm) UL listed strain relief
(UL marking on strain relief). Put the tabs of the two clamp
sections (C) into the hole below the terminal block opening
(B) so that one tab is pointing up (A) and the other is pointing
down (D), and hold in place. Tighten strain relief screws just
enough to hold the two clamp sections (C) together.
A. Strain relief tab pointing up
B. Hole below terminal block opening
C. Clamp section
D. Strain relief tab pointing down
A
B
C
D
2.
Attach power supply cord
to strain relief
Put power supply cord through the strain relief. Be sure that
the wire insulation on the power supply cord is inside the strain
cabinet and be in a horizontal position. Do not further tighten
strain relief screws at this point.
4-wire Power Supply Cord Connection
IMPORTANT:
homes and where local codes do not permit the use of
Spade terminals
with upturned ends
Ring terminals
11