Sears Kenmore 110.81422 Manual De Uso Y Cuidado página 30

To use Laundry Center again
1. Flush water pipes and hoses.
2. Reconnect water inlet hoses.
3. Turn on both water faucets.
4. Plug in Laundry Center or reconnect power.
5. Run the washer through a complete cycle with 1 cup (250 mL)
of detergent to clean out antifreeze.
To transport the Laundry Center
1.
2. Disconnect and drain water inlet hoses.
3. If Laundry Center will be moved during freezing weather,
on a spin setting for about 30 seconds to mix the antifreeze
and water.
4. Disconnect the drain hose from the drain system.
5. Unplug Laundry Center or disconnect power. Disconnect wiring
if Laundry Center is direct wired (240 volt model only).
6. Disconnect the exhaust vent.
7. Wash lint screen.
8. Make sure leveling legs are secure.
9. Place the inlet hoses into the basket.
10. Place the foam packing ring (removed during installation)
in the washer to keep the washer tub stable during transport.
11. Drape the power cord and drain hose over edge
and into the basket.
12. Use tape to secure the washer lid and dryer door.
30
Reinstalling your Laundry Center
1. Follow the "Installation Instructions" to locate, level, and
connect the Laundry Center.
2. Run the washer through a complete cycle with 1 scoop or
capful of detergent to clean the washer and remove the
antifreeze, if used.