Warnings For The Installer - Vimar RS02 Manual De Instrucciones Para La Conexión Y El Uso

RS02
Contents:
Warnings for the installer
1 - Characteristics .........................................................................................................................................................................................................................25
2 - Description of the control panel.....................................................................................................................................................................................................25
3 - Risk assessment..............................................................................................................................................................................................26
4 - Electrical wiring harnesses...................................................................................................................................................................................................................26
5 - Description of LEDs and buttons on the circuit....................................................................................................................................................................................31
6 - Set the type of actuator................................................................................................................................................................................31
7 - Quick programming....................................................................................................................................................................................................32
8 - Complete programming..................................................................................................................................................................................................34
9 - Summary flowchart....................................................................................................................................................................................................40
10 - Installing batteries...............................................................................................................................................................................................................................43
11 - Troubleshooting..............................................................................................................................................................................................................................43
12- Programmable parameters...........................................................................................................................................................................................................44
13- Installing the card on the 12V sliding ACTUATors with optical encoder.........................................................................................................46

WARNINGS FOR THE INSTALLER

- Carefully read all instructions and warnings in this document as they provide important information regarding safety during installation, operation
and maintenance.
- After removing the packaging, check the condition of the device. Packaging materials must be kept out of the reach of children as they constitute a
hazard. Installation must be carried out in accordance with national safety regulations.
- This device must only be used for the purpose for which it was expressly designed. Any other use is considered improper and therefore hazard-
ous. The manufacturer declines all liability for damage caused by improper, incorrect or unreasonable use.
- Always disconnect the appliance from the power supply at the main switch before performing maintenance or cleaning procedures.
- In the event of faults and/or malfunctions, disconnect the appliance from the power supply immediately at the switch and do not tamper with any
of its parts. For repairs, contact only a service centre authorized by the manufacturer. Failure to observe the above may jeopardize the safety
of the device.
- All appliances within the system must be used exclusively for the purpose for which they are intended.
- This document must always be kept with all other documentation regarding the installation.
Directive 2002/96/EC (WEEE).
The crossed out bin symbol on the appliance indicates that the product, at the end of its useful working life, must be disposed of separately from
normal household waste, and as such must be taken to a waste sorting and recycling centre equipped to deal with electric and electronic equip-
ment, or returned to the dealer when a new appliance of the same type is purchased.
The user is responsible for ensuring the appliance is disposed of through the correct channels when no longer in service. Proper sorted waste
collection for subsequent recycling, processing and environmentally conscious disposal of the old appliance helps to prevent any possible negative
impact on the environment and human health while promoting the practice of recycling materials used in manufacture. For more detailed informa-
tion regarding available waste collection systems, contact your local waste disposal service or the shop from which the appliance was purchased.
Risks associated with substances considered hazardous (WEEE).
According to the new WEEE Directive, substances which for some time have been widely used in electrical and electronic equipment are consid-
ered hazardous to human heath and the environment. Proper sorted waste collection for subsequent recycling, processing and environmentally
conscious disposal of the old appliance helps to prevent any possible negative impact on the environment and human health while promoting the
practice of recycling materials used in manufacture.
The product complies with European Directive 2004/108/EC and subsequent amendments.
22
EN
P a g e