Contents:
1 - characteristics. ............................................................................................................................................................................................................25
2 - description of the control panel ...................................................................................................................................................................................25
3 - risk assessment ...........................................................................................................................................................................................................26
4 - electrical wiring harnesses ..........................................................................................................................................................................................26
6 - quick programming ......................................................................................................................................................................................................31
7 - complete programming ................................................................................................................................................................................................33
8-
summary flowchart ......................................................................................................................................................................................................41
9 - installing batteries ........................................................................................................................................................................................................44
10 - troubleshooting ............................................................................................................................................................................................................44
11- programmable parameters ..........................................................................................................................................................................................44
12- user name remote control association ........................................................................................................................................................................45
WARNINGS FOR THE INSTALLER
- Carefully read all instructions and warnings in this document as they provide important information regarding safety during installation, operation
and maintenance.
- After removing the packaging, check the condition of the device. Packaging materials (plastic bags, expanded polystyrene, etc.) must be kept out of the
reach of children as they constitute a hazard. Installation must be carried out in accordance with national safety regulations.
- A suitable omnipolar switch should be fitted in an easily accessible site upline of the power mains, with a minimum gap between contacts of 3 mm.
- Before connecting the appliance, check that the rated power corresponds to that of the mains supply.
- This appliance must be used only for the purpose for which it was expressly intended, GB.e. for interphone systems. Any other use is considered
improper and therefore hazardous. The manufacturer declines all liability for damage caused by improper, incorrect or unreasonable use.
- Always disconnect the appliance from the power supply at the main switch before performing maintenance or cleaning procedures.
- In the event of faults and/or malfunctions, disconnect the appliance from the power supply immediately at the switch and do not tamper with any of
its parts. For repairs, contact only a service centre authorized by the manufacturer. Failure to observe the above may jeopardize the safety of the
device.
- Never obstruct openings or outlets used for ventilation or heat dispersion and never expose the appliance to dripping or sprayed water.
- The installer must ensure that user information is applied to extension appliances.
- All appliances within the system must be used exclusively for the purpose for which they are intended.
- This document must always be kept with all other documentation regarding the installation.
Directive 2002/96/EC (WEEE).
The crossed out bin symbol on the appliance indicates that the product, at the end of its useful working life, must be disposed of separately from nor-
mal household waste, and as such must be taken to a waste sorting and recycling centre equipped to deal with electric and electronic equipment, or
returned to the dealer when a new appliance of the same type is purchased.
The user is responsible for ensuring the appliance is disposed of through the correct channels when no longer in service. Proper sorted waste collection
for subsequent recycling, processing and environmentally conscious disposal of the old appliance helps to prevent any possible negative impact on
the environment and human health while promoting the practice of recycling materials used in manufacture. For more detailed information regarding
available waste collection systems, contact your local waste disposal service or the shop from which the appliance was purchased.
Risks associated with substances considered hazardous (WEEE).
According to the new WEEE Directive, substances which for some time have been widely used in electrical and electronic equipment are considered
hazardous to human heath and the environment. Proper sorted waste collection for subsequent recycling, processing and environmentally conscious
disposal of the old appliance helps to prevent any possible negative impact on the environment and human health while promoting the practice of
recycling materials used in manufacture
The product complies with European Directives 2004/108/EC, 2006/95/EC, 2006/42/EC, R&TTE 99/05/EC, 89/106/EC.
24
.
Page
EN