Troubleshooting - Teac TN-550 Manual Del Usuario

If you experience a problem with this unit, please check the
following items before requesting service. Something other
than this unit could also be the cause of the problem. Please
also check that the connected devices are also being used
properly.
If it still does not operate correctly, contact the retailer where
you purchased the unit.
No power.
e Confirm that the AC adapter is plugged into an outlet.
Then, press the STANDBY/ON button to turn the unit
on (page 8).
Volume is low.
e Confirm the connections (page 8).
10

Troubleshooting

Playback is not possible; there is noise.
e Raise the protector (page 9).
e Clean the stylus (page 4).
e If the stylus is worn-out, replace it (page 4). The lifes-
pan of a needle depends on the use conditions, but it is
usually about 300 hours.
e Place the unit as far away as possible from TVs,
microwave ovens and other devices that emit electro-
magnetic waves.
Noise occurs when a record is playing
e Noise could occur if the stylus pressure is higher than
cartridge's specified value. Readjust the stylus pressure
so that it is the specified value (page 5).
The pitch is wrong.
e Set the rotation speed (RPM) to match the record (page
9).
The sound is skipping.
e Vibrations will cause skipping. Place this unit in a stable
location.
e If the record is dirty, wipe it clean.
e Do not use scratched records.
e Balance the tone arm and readjust the stylus pressure
(page 5).
If the stylus pressure is lower than the value designated
by the cartridge, skipping is more likely to occur.