Preparing The Record Player - Teac TN-550 Manual Del Usuario

E
Keep the unit in standby while setting it up ( on page
8).
1
Place it on a flat surface.
2
Install the turntable.
Align the turntable with the center shaft and install it.
o Place the large side of the hole down.
Center shaft
Turntable
3
Loop the belt around the motor pulley.
Loop the included rubber belt around the outside of
the turntable, and then loop the belt around the motor
pulley.
o Be careful not to let the rubber become twisted.
o Rotate the turntable several times to make sure that
it is secure.
Motor pulley
Rubber belt

Preparing the record player

4
Install the pulley cover.
Align the small cutout in the pulley cover with the small
protuberance on the pulley, as shown in the illustra-
tion below. If these are not aligned, the pulley cover
will slant.
Pulley cover
5
Place the turntable mat on the
turntable.
Place the mat that is included with the turntable on it
before use.
6
Install the counterweight.
Place the counterweight over the end of the tone arm,
and press it gently as you turn it right to attach it.
Counterweight
7
Install the headshell.
Insert the headshell on the end of the tone arm and
turn the nut to secure it in place.
Nut
Headshell
Confirming levelness and fine-tuning
In order to confirm the level placement of the turntable, we
recommend using, for example, a commercially-available
turntable leveling device. If the turntable is not level, follow
the procedures below to adjust the heights of the feet to level
the unit.
o If the slant is too great, the following method might not
be able to correct it.
1
Turn the foot on the low side counter-
clockwise to remove it.
2
Attach one of the included washers.
Washer
Foot
3
Reattach the foot in its original
position.
4
Press down on the four corners of the
unit to confirm that the weight is dis-
tributed evenly on the four feet.
If one of the feet is wobbly, attach a washer to it as
explained above and adjust its height.
Balancing the tone arm and adjusting
the stylus pressure
Counterweight
Stylus pressure adjustment ring
Center line
Anti-skating
Arm lifter
1
Set the anti-skating dial to zero.
2
Raise the arm lifter and shift the tone
arm to the left slightly.
3
Lower the arm lifter.
4
Turn the counterweight and adjust so
that the tone arm is level.
o Lower the protector to prevent damage to the car-
tridge stylus before making adjustments.
o Be careful not to let the cartridge stylus touch the
unit.
Continued on the next page
e
5