Adjusting The Tone Arm Height - Teac TN-550 Manual Del Usuario

5
Return the tone arm to its original
position, and place it on the tone arm
holder.
6
Turn the stylus pressure adjustment
ring so that the center line aligns with 0
on the scale.
o Only turn the ring. Be careful not to let the counter-
weight turn.
7
Turn the counterweight so that the
stylus pressure adjustment ring scale
matches the stylus pressure specified
for the cartridge.
o The stylus pressure of the included cartridge is 1.4 g.
So, turn it to 1.4 on the counterweight scale when
using the included cartridge.
o Turn it right from 0 in the direction of 0.5 and 1.0.
6
Preparing the record player (continued)
8
Adjust the anti-skating dial.
Start with it set at 1.4 and adjust it during record play-
back (page 9) to the position where the left and
right volumes are balanced.

Adjusting the tone arm height

Follow the procedures below to adjust the tone arm height
if it is not level during record playback after changing the
cartridge or headshell.
1
Place a record on the turntable, and
put the record needle on the edge of
the record.
o Do not let the turntable turn.
2
Insert the included hex wrench into
the height adjustment screw hole and
turn it counterclockwise to unlock the
tone arm base.
Height adjustment
screw hole
Pedestal
Tone arm base
3
Hold the tone arm base, and adjust the
height to make the tone arm level.
o Be careful not to let the tone arm move right or left
when adjusting the height.
4
Turn the hex wrench clockwise to lock
the tone arm base.
Alignment position
That tone arm base can move left and right relative to
the pedestal. Align the guideline (white) on the tone arm
base to the 5 mark on the pedestal before locking it.
5
Play the record and confirm that the
tone arm is now level.