Control Panel And Features - Maytag 4GMVWC100 Manual De Uso Y Cuidado

Lavadora de carga superior
Ocultar thumbs Ver también para 4GMVWC100:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CONTROL
PANEL AND FEATURES
O
O
O
O
O
4
Not all features and options are available on all models.
Appearance
may vary.
WATER
LEVEL
Select the setting most suitable for your load. Small will add
a low amount of water for smaller loads and Super Plus will
add the most amount of water for large or bulky loads. Items
need to move freely. Tightly packing can lead to poor clean-
ing performance,
and may increase wrinkling and tangling.
TEMPERATURE
Temperature Control senses and maintains uniform water
temperatures
by regulating incoming hot and cold water.
Select a wash temperature
based on the type of fabric
and soils being washed. For best results and following the
garment label instructions, use the warmest wash water safe
for your fabric.
* Warm and hot water will be cooler than what your previous
washer provided.
* Even in a cold and cool water wash, some warm water
may be added to the washer to maintain a minimum
temperature.
WASH
CYCLE
KNOB
Use the Wash Cycle knob to select available cycles on your
washer. Turn the knob to select a cycle for your laundry load.
See "Cycle Guide" for detailed descriptions
of cycles.
FABRIC
SOFTENER
This option can be added to most cycles and must be set to
"YES" if using fabric softener during a cycle. It ensures that
fabric softener is added at the correct time in the rinse for
even distribution.
START/PAUSE/UNLOCK
BUTTON
Press to start the selected cycle; press again to pause the
cycle and unlock the lid.
NOTE: If the washer is spinning, it may take several minutes
to unlock the lid. Press and hold for 3 seconds to cancel a
cycle.
O
CYCLE
STATUS
LIGHTS
fill
wash rinse
spin
done [idlocked
The Cycle Status Lights show the progress of a cycle. At
each stage of the process, you may notice sounds or pauses
that are different from traditional washers.
SENSING/FILL
flu
wash
rinse
spin
done lid locked
When the START/Pause/Unlock
button is pressed, the
washer will fill to the selected water level. If the lid is
closed when the machine is done filling, the lid will lock
and the machine will begin operation.
If the lid is open when the water stops entering the ma-
chine, the cycle will not begin until the lid has been closed
and the START/Pause/Unlock
button is pressed. If the
cycle has not been started within 10 minutes of the water
filling the washer, the washer will pump out the water.
NOTE: Avoid opening lid during sensing phase. The
sensing process will start over when the washer is
restarted. The sensing light may also come on during the
Soak and Wash portions of the cycle. This is normal. To
restart the washer after the lid has been opened, press
Start.
WASH
flu
wash
rinse
spin
done iidlocked
You will hear the agitator moving the load. The motor
sounds may change at different stages in the cycle. The
wash time is determined
by the selected soil level.
RINSE
fill
wash
rinse
spin
done lidlocked
You will hear sounds similar to the wash cycle as the
washer rinses and moves the load. You may hear the
motor turning on briefly (short hum) to move the basket
while filling. Fabric softener will be added if the Fabric
Softener-Yes option was selected.
Some cycles use spray rinsing. After draining and
spinning out wash water, the washer will continue to spin
and spray in rinse water for the entire rinse time.

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

4gmvwc300

Tabla de contenido