Installing Or Replacing Roll Paper; Inserting Slip Paper - Epson TM-J7000 Manual Del Usuario

Installing or Replacing Roll Paper

CAUTION:
Be careful not to insert your fingers into the paper exit. The cutter blade
is installed inside the paper exit and you might be injured.
See illustration D.
CAUTION:
Be sure to use roll paper that meets the specifications.
Follow these steps to install or replace paper:
1. Make sure the printer is on.
2. Open the roll paper cover by pressing the cover open button.
See illustration E.
3. Remove the used roll paper core if there is one.
4. Put the roll paper inside the printer in the correct direction, as
shown in illustration F.
5. Pull out the leading edge of the roll paper; then close the roll
paper cover until it is firmly locked by pushing the top of the
cover.
6. The printer will automatically feed the roll paper to remove
any slack in the paper.
Note:
Do not open the roll paper cover during printing or paper feeding.

Inserting Slip Paper

Note:
Be sure the paper is flat, without curls, folds, or wrinkles.
Do not insert any multiple sheet paper, as this may cause a paper jam.
Use only single sheet paper.
Because the printer is an inkjet printer, pressure sensitive copy paper
cannot be used.
To prevent jams, roll paper must be installed even for printing on slip
paper.
Be sure to insert a slip with the right side of the paper against the
right side of the paper guide as far as it will go, as shown in
illustration G. See the label instructions attached to the printer as a
guide.
TM-J7000/J7100 User's Manual 7
English